Northern Telecom DMS-100 Series Maintenance Manual page 197

Procedure 6-5
AMA messages - procedures
6 Craftsperson Activity
Notes:
Note 1: The AMAHRS (cr) entry and response allows the Craftsperson to determine that the AMA hours currently assigned
are active for reporting purposes. If hours are not correct, go to step ii.
Note 2: Perform the SITDAT WRITE command immediately after completion of the AMAHRS data entry to save the new
data to disk.
Automatic message accounting (AMA) messages 6-7
a. Verify that data should be received at this time
i) To examine the hour boundaries currently
assigned,
- Enter:
>AMAHRS (cr)
ii) To assign or change hour boundaries,
- Enter:
>AMAHRS Start Stop
b. If the message repeats during the next reporting
period, call for technical assistance. (Problem
may be in the DMS-100.)
End
DPP Recovery and Routine Maintenance Guide BCS35 and up
(at the terminal)
1
Proper response = BLOCK CHECK
START xx END xx HOURS
where: xx = hour of day
(at the terminal)
2
(cr)
where:
Start = 00 - 23 = starting hour
(less than 24).
Stop = Start time minus 23 = stop-
ping hour (greater than starting hour
but less than 24).
If full time hourly block checks are
required, enter 00 for Start and 23
for Stop.
If no hourly block checks are re-
quired, enter 00 for Start and 00 for
Stop.