Northern Telecom DMS-100 Series Maintenance Manual page 84

4-50 Disk drive procedures
Procedure 4-22
Disk condition and disk file error messages - procedures
1
DSK MSG xx:
00 = MSG RCVD PARM DISK 02 = WRT MEM COMPLETE
0B = RST-7
0E = INIT FAILED
12 = INIT NOT ALLOWED
15 = NO DSK ON LINE
18 = DSK NOT READY
1B = SIDE
1E = FAILED SELF TEST
21 = DSK JOB
24 = BUS ERROR
27 = PARM CHANGE NOT
ALLOWED
2A = DSK PROC IN PROG
2D = BACKUP FAILED
2 Alarm Level:
N/A; (the DPP system is already
in a catastrophic alarm condition
for some other reason)
3 Customer-Selected
Alarm Level
4 Other Alarm Indications
5 System Recovery Action
297-1001-537 Standard 01.02 December 1993
where: xx = cross-references to software message(s).
These responses appear during disk activities in
the monitor mode. System software is not
running.
0C = QTY BAD TRACKS
0F = UNINIT SYS OR BAD DISK 10 = VERSION MSG
13 = NO DSK PARM
16 = BOTH DSK PREFERRED
19 = DSK ALARM
1C = DMA REGISTERS
1F = INTRPT WHILE IDLE
22 = CMD ATTEMPTED WHILE 23 = STATUSES, STAGE,
BUSY
25 = DATA XFER BYPASSED
28 = FORMAT NOT ALLOWED 29 = TIME OUT
2B = FORMAT DONE
cause: disk message(s) as output during boot mode.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type: N/A
Type:
Default:
Status Panel: Minor
Customer-Selected
Status Panel:
If a disk error message was indicated in "xx", the
recovery action is based on the indicated disk error
message.
(continued)
04 = OUTPUT COMPLETE
0D = INIT COMPLETE
14 = DSK FAIL GOING ON LINE
17 = ILLEGAL MODE CHANGE
1A = DSK MODE
1D = DMS INTRPT
20 = CMD ERROR
DRIVE, CMD
26 = DSK NOT INITED
2C = FORMAT FAILED
Level: N/A
Level:
Audible: Minor
Audible: