Northern Telecom DMS-100 Series Maintenance Manual page 117

Procedure 4-41
Disk drive hardware error messages - procedures
1
DISK NOT INITIALIZED
(w/o 56K polling)
2 Alarm Level:
Disk mode non-redundant
3 Customer-Selected
Alarm Level
4 Other Alarm Indications
5 System Recovery Action
6 Craftsperson Activity
cause: printed in response to the DISK MODE xx
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Default:
Status Panel:
Customer-Selected
Status Panel:
Leaves disk in ONLY mode.
a. Initialize the disk.
CAUTION
Improper performance of this procedure may cause a loss of data.
Make sure the operational disk drive is in DISK ONLY mode
before entering commands.
Select:
(continued)
DPP Recovery and Routine Maintenance Guide BCS35 and up
command when an uninitialized disk is requested
to go on line.
Type: N/A
Type:
i) The recommended procedure is Procedure 4-5.
ii) The alternate procedure is Procedure 4-6.
(When init activity is complete, go to step b.)
Disk drive procedures 4-83
Level: N/A
Level:
Audible:
Audible: