Set Ip Address; Disclaimer - MICRO-EPSILON interferoMETER IMS5400-DS19 Quick Manual

Set IP Address

Set IP Address
Change to the menu Settings > Outputs > Ethernet Settings and enter the new IP address.
Click on Apply settings to confirm.
Start the web interface with the new IP address.
Save the new device settings. Click on Save settings.

Disclaimer

All components of the device have been checked and tested for functionality in the factory. However, should any de-
fects occur despite careful quality control, these shall be reported immediately to MICRO-EPSILON or to your distribu-
tor / retailer.
MICRO-EPSILON undertakes no liability whatsoever for damage, loss or costs caused by or related in any way to the
product, in particular consequential damage, e.g., due to
- non-observance of these instructions/this manual,
- improper use or improper handling (in particular due to improper installation, commissioning, operation and
maintenance) of the product,
- repairs or modifications by third parties,
- the use of force or other handling by unqualified persons.
This limitation of liability also applies to defects resulting from normal wear and tear (e.g., to wearing parts) and in the
event of non-compliance with the specified maintenance intervals (if applicable).
MICRO-EPSILON is exclusively responsible for repairs. It is not permitted to make unauthorized structural and / or
technical modifications or alterations to the product. In the interest of further development, MICRO-EPSILON reserves
the right to modify the design.
In addition, the General Terms of Business of MICRO-EPSILON shall apply, which can be accessed under Legal de-
tails | Micro-Epsilon https://www.micro-epsilon.com/impressum/.
For translations into other languages, the German version shall prevail.
IMS5x00 Page 31