Set Ip Address; Service, Repair; Liability For Material Defects - MICRO-EPSILON interferoMETER IMS5400-DS Quick Manual

Set IP Address

Set IP Address
Change to the menu Settings > Outputs >
Ethernet Settings and enter the new IP ad-
dress.
Click on Apply settings to confirm.
Start the web interface with the new IP address.
Save the new device settings. Click on Save set-
tings.

Service, Repair

If the sensor, controller or sensor cable is
defective:
- If possible, save the current sensor settings in a pa-
rameter set to reload them into the controller after the
repair.
- Please send us the affected parts for repair or ex-
change.
If the cause of a fault cannot be clearly identified, please
send the entire measuring system to:
MICRO-EPSILON
MESSTECHNIK GmbH & Co. KG
Koenigbacher Str. 15
94496 Ortenburg / Germany
IMS5x00

Liability for Material Defects

All components of the device have been checked and
tested for functionality at the factory. However, if defects
occur despite our careful quality control, MICRO-EPSI-
LON or your dealer must be notified immediately.
The liability for material defects is 12 months from deliv-
ery. Within this period, defective parts, except for wear-
ing parts, will be repaired or replaced free of charge, if
the device is returned to MICRO-EPSILON with shipping
costs prepaid. Any damage that is caused by improper
handling, the use of force or by repairs or modifica-
tions by third parties is not covered by the liability for
material defects. Repairs are carried out exclusively by
MICRO-EPSILON.
Further claims can not be made. Claims arising from the
purchase contract remain unaffected. In particular, MI-
CRO-EPSILON shall not be liable for any consequential,
special, indirect or incidential damage. In the interest
of further development, MICRO-EPSILON reserves the
right to make design changes without notification.
For translations into other languages, the German ver-
sion shall prevail.
Tel. +
49 (0) 8542 / 168-0
@micro-epsilon.de
info
www.micro-epsilon.com
Page 19