Notices On Handling / Recycling /Disposal Printing Materials; Printing Material; Printing Process; Laser Module - XYZ Printing PartPro150 xP Operation Manual

Version 1.0
PartPro150 xP Operation Manual

NOTICES ON HANDLING / RECYCLING /DISPOSAL PRINTING MATERIALS

 Keep the storage of the printing materials locked up and out of the reach of children.
 Always wear the chemical-resistant gloves to prevent direct contacting with printing materials.
 Wasted resin can be pulled into plastic bag and cured under sunlight or UV light source. Cured
resin can be discarded as office waste.
 Be careful not to spill the resin material.
 Do not mix the resin with incompatible materials.
 Do not drain the printing materials or waste solution into sewer systems or with household
wastewater.
 Follow local regulations for disposing the wipers dampened with the printing materials.

PRINTING MATERIAL

 The stability of printing quality is affected by temperature and humidity. Please ensure that the
recommended operating conditions are adhered to (Operating temperature 20-30℃ (68-86
℉)/humidity 40-80% RH)

PRINTING PROCESS

 Keep the covers securely closed during printing.
 The printing quality may be affected if resin temperature is changed due to opening the cover(s).

LASER MODULE

 The Laser Module will emit lasers only after the printing starts.
 The Laser Module will automatically shut down if any of the protective cover is open.

NOTE ON POWER SUPPLY

 Do not use with damaged cord or plug. To unplug grasp the plug, not the cord. Do not handle plug
or machine with wet hands. Turn off the power switch before unplugging.
 Do not run the machine over cord. Keep cord away from heated surfaces.
 If the system is left in idle mode for an extended amount of time, turn off the main switch.
3