Mitsubishi Electric NZ2GF-ETB User Manual page 199

The following table lists the setting items on the dialog box.
Item
Equipment
Name
Name Setting
Comment
TCP Connection
Input
Format
*3
Destination Port No.
Port No.
Input
Format
*3
Destination IP Address
IP Address
*1 Unpassive: Allows connections with no restrictions on the IP address and port number of the destination.
*2 Fullpassive: Allows connections only when the IP address and port number of the destination meet the specified ones. If
an external device with any other IP address and/or port number tries to open a connection, the line will be automatically
disconnected.
However, if the destination port number and destination IP address are set to default values, connections are allowed
with no restrictions on the IP address and port number of the destination.
*3 No setting is required when "Unpassive" is set for "TCP Connection".
Description
Enter an equipment name.
Enter a comment.
Select a TCP connection type.
Set this item only when "TCP" is selected for "Protocol" in the
"Ethernet Port Connection Setting" window.
There are two TCP connection types: Unpassive
*2
Fullpassive .
Select a format used for entering the port number of the
external communication-target device.
Enter the port number of the external device with which
communications are made.
Select a format used for entering the IP address of the external
communication-target device.
Enter the IP address of the external device with which
communications are made.
CHAPTER 10 CONFIGURATION TOOL
Setting range
8 characters or less
(Default: Eqpt-1-Connection No.)
32 characters or less
(Default: Connection-Connection No.)
Unpassive/Fullpassive
(Default: Unpassive)
*1
and
DEC/HEX
(Default: HEX)
• Decimal input
1 to 65535 (Default: 65535)
• Hexadecimal input
1 to FFFF (Default: FFFF
H H
DEC/HEX
(Default: DEC)
• Decimal input
0.0.0.1 to 255.255.255.255
(Default: 255.255.255.255)
• Hexadecimal input
0.0.0.01 to FF.FF.FF.FF
(Default: FF.FF.FF.FF)
10
)
H
197