Mitsubishi Electric NZ2GF-ETB User Manual page 36

(3) Ethernet part
Item
For users
Number of For auto-open
connections
For MELSOFT
connection
Own Station Port No.
Number of simultaneously connectable
modules
Communication speed
Communication mode
Transmission system
For 1Gbps
Connection
cable
For 100Mbps
Maximum distance between switching
hub and node
Number of cascade connections
*1 To use two or more TCP connections for a MELSOFT Connection, user connections can be assigned to MELSOFT
Connection. ( Page 195, Section 10.3.3 (2))
*2 Use of double shielded cables is recommended in a high noise environment.
● When connected to a switching hub, the Ethernet adapter module detects and sets 1000BASE-T or 100BASE-TX and
full-or half- duplex communication mode according to the switching hub. When the connected switching hub does not
support the auto-negotiation function, set the switching hub to the half-duplex communication mode.
● The operation of the following connections is not guaranteed. Check the operation at the user's discretion before use.
• Connections using the Internet (public line) (Internet connection services by Internet service providers or
telecommunications carriers)
• Connections using firewall devices
• Connections using broadband routers
34
32
1
3 (TCP connection: 1
1025 to 4999, 5011 to 65534 (0401
Up to 32
1Gbps or 100Mbps
Full- or Half-duplex
Base band
An Ethernet cable that meets the 1000BASE-T standard:
Category 5e or higher, (Double shielded/STP), Straight cable ( Page 49, Section 5.2.2 (1))
An Ethernet cable that meets the 100BASE-TX standard:
*2
Category 5 or higher, (STP), Straight cable ( Page 49, Section 5.2.2 (1))
Up to 100m
Up to 20
Specification
*1
, UDP connection: 1, Direct connection: 1)
to 1387 , 1393
H H
to FFFE )
H H