Mitsubishi Electric NZ2GF-ETB User Manual page 97

(5) Setting data
(a) Connection No.
Set the connection No. where on-demand data is sent from the Ethernet adapter module.
Connection
*1
Connection for users
Auto-open UDP port
If any number other than those described above is set, a connection No. error (error code: 420
Page 161, Section 9.5)
*1 This corresponds to the connection No. in the connection setting in the configuration tool. ( Page 195, Section
10.3.3 (2))
(b) Frame setting format
Specify whether a serial No. is added to on-demand data.
Frame setting format
No serial No. added
Serial No. added
If any number other than those described above is set, a frame setting format error (error code: 421
( Page 161, Section 9.5)
(c) Serial No.
Set the serial No. added to the subheader of on-demand data.
The serial No. is effective only when the frame setting format is set to the serial No. added (1
When the communication data code set in the connection setting is an ASCII code, the setting value is
converted from the binary data to the ASCII code and sent.
(d) Communication data code specification (when using the auto-open UDP port)
Set the communication data code required when using the auto-open UDP port.
(When using TCP, follow the connection setting in the configuration tool.)
ASCII conversion specification
Binary code communication
ASCII code communication
If any number other than those described above is set, a communication data code specification error (error
code: 422 ) occurs. ( Page 161, Section 9.5)
H
CHAPTER 7 COMMUNICATION OF THE ETHERNET ADAPTER MODULE
Setting value
Setting value
Setting value
1 to 32
0
) occurs. (
H
0
H
1
H
) occurs.
H
).
H
0
H
1
H
7
95