Mitsubishi Electric NZ2GF-ETB User Manual page 117

5.
Click the [Routing Parameters] button to set the communication route.
The communication route needs to be set so that communications reach the network of the Ethernet
adapter module (Ethernet part). Because Ethernet adapter modules do not have routing parameters, set
the routing parameters of the master station to perform communications.
IP address
3
Ethernet
192.168. .1
CC-Link
IE Field
Network
Network No.
*1 This IP address is set on "Ethernet" in the configuration tool. ( Page 121, Section 7.3.5 (1))
Item
Target Network No.
Relay Network No.
Relay Station No.
CHAPTER 7 COMMUNICATION OF THE ETHERNET ADAPTER MODULE
3
*1
192.168. .30
192.168.1.1
(Automatically assigned)
Station No.1
Network No.1
3
Set the network No. of the external device side to be communicated with.
In this setting example, set the third octet of the IP address set in "Ethernet" of the
Ethernet adapter module.
Set the network No. of the station where communications transmit through to
reach the target network No.
In this setting example, set the network No. set in "CC-Link IE Field Network" of
the Ethernet adapter module.
Set the station No. of the station where communications transmit through to reach
the target network No.
In this setting example, set the station No. set in "CC-Link IE Field Network" of the
Ethernet adapter module.
192.168.
192.168.1.2
192.168.1.125
(Automatically assigned)
Master station
Station No.2
Network No.1
Description
2 2
*1
.30 192.168. .1
2
Network No.
Communication route
to the network No.2
Communication route
to the network No.3
115
7