Connection To Ethernet - Mitsubishi Electric NZ2GF-ETB User Manual

7.3.5

Connection to Ethernet

(1) Setting in the Ethernet adapter module
Set the IP address of the Ethernet adapter module (Ethernet part) using the configuration tool.
1.
Start up the configuration tool using a Web browser. ( Page 184, Section 10.1.2)
2.
Open the "Parameter Setting" dialog box in the configuration tool to set the parameters as follows.
Setting item tree  NZ2GF-ETB  [Parameter Setting]  "Ethernet"
• Setting on the request source: Set the IP address and subnet mask pattern of the Ethernet adapter
module (Ethernet part).
• Setting on the request destination: Set the IP address and subnet mask pattern of the Ethernet adapter
module (Ethernet part).
3.
In the "Parameter Setting" dialog box, click the [End] button.
4.
Write the set parameters to the Ethernet adapter module by the same procedure as parameter
setting for connecting the module to CC-Link IE Field Network. ( Page 118, Section 7.3.4 (2))
CHAPTER 7 COMMUNICATION OF THE ETHERNET ADAPTER MODULE
7
121