Checking Communications (Ip Communication Test) - Mitsubishi Electric NZ2GF-ETB User Manual

7.3.6

Checking communications (IP communication test)

After the following settings are completed, communications using the IP address can be performed between the
external devices.
• Network setting of the configuration computer ( Page 111, Section 7.3.3)
• Connection to CC-Link IE Field Network ( Page 112, Section 7.3.4)
• Connection to Ethernet ( Page 121, Section 7.3.5)
Use the IP communication test of the configuration tool to check that communications can be performed. The following
items can be checked:
• The cables on the communication route are properly connected.
• The parameter settings that are required for IP communications in an external device on the communication
route, such as the IP address, routing parameters on the master and local stations, and CC-Link IE Field
Network gateway setting on the Ethernet adapter module, are correct.
• Modules, such as a CPU module, master/local module, and Ethernet adapter module, that do not support
the IP packet transfer function are connected or not on the communication route.
124