Ethernet Connection; Connection With Melsoft Products And A Got - Mitsubishi Electric RD78G4 User Manual

1.3

Ethernet Connection

Connection with MELSOFT products and a GOT

Programming and monitoring of the programmable controller with the engineering tool, and monitoring and testing of the
programmable controller from the GOT is performed via Ethernet. This function enables remote control using Ethernet's long-
distance connectivity and high-speed communications.
The section describes the methods of connecting the Motion module, MELSOFT product (such as engineering tool and MX
Component), and GOT.
: Connection available, : Connection not available
Connection method
Connection via hub
(Connection by specifying the IP
address)
Connection via hub
(Connection by specifying the network
No. and station No.)
For the procedures to connect the Motion module and GOT, refer to the following.
 Manual for the GOT used
Connection via hub
■Settings on the Motion module side
Sets the IP address of the Motion module using "Required Settings". ( Page 36 Station No./IP Address Settings)
When connecting by specifying the network No. and station No., set the network No. and station No. in "Required Settings".0
The Motion module can be connected to the MELSOFT product and GOT using the system dedicated connection, so no
settings are required in "Network Configuration Settings" under "Basic Settings".
Purpose
To connect multiple MELSOFT products
To connect multiple MELSOFT products and GOTs
Availability
MELSOFT GOT
product
 
 
1 FUNCTIONS
1.3 Ethernet Connection
1
Reference
Page 19
Connection via hub
19