Printing Photos From A Pictbridge-Enabled Digital Camera - Lexmark Pro915 User Manual

Lexmark pro915: user guide
Hide thumbs Also See for Pro915:
Table of Contents

Advertisement

Printing photos from a PictBridge-enabled digital camera

PictBridge is a technology available in most digital cameras that lets you print directly from your digital camera
without using a computer.
1
Insert one end of the USB cable into the camera.
Note: Use only the USB cable that came with the camera.
2
Insert the other end of the cable into the PictBridge port on the front of the printer.
Notes:
Make sure that the PictBridge-enabled digital camera is set to the correct USB mode. If the camera USB
selection is incorrect, then the camera is detected as a flash drive, or an error message is displayed on the
printer control panel. For more information, see the camera documentation.
The printer reads only one memory device at a time.
3
If the PictBridge connection is successful, then the following message appears on the display: Camera
Connected. Use Camera to choose and print photos.
4
If you want to change the default print settings:
a
Touch More Options to access the PictBridge menu.
b
Select the paper source, paper size, paper type, photo size, quality, and layout of the photos that you want to
print. Touch Accept each time you make a selection.
Note: The printer will use the default print settings unless you change the print settings from the camera.
5
See the documentation for your camera to begin printing.
Note: If you insert the camera while the printer is performing another job, then wait for the job to finish before
printing from the camera.
Warning—Potential Damage: Do not touch any cables, any network adapter,
any connector, the memory device, or the printer in the areas shown while
actively printing, reading, or writing from the memory card. A loss of data can
occur.
Printing
48

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pro910 series4449901

Table of Contents