Safety Measures In Normal Operation; Commissioning, Maintenance And Repair - Fronius Robacta TC 2000 Operating Instructions Manual

When setting up the device, ensure an all-round clearance of at least 0.5 m
(19.69 in.) from any surrounding objects, e.g. walls, other devices or objects.
The device must be set up at least 1 m (40 in.) away from computers, control
lines and the welding process.
Position the device to prevent welding spatter coming into contact with the
cleaning device.
Before transporting the device, allow parting agent to drain completely.
When transporting the device, observe the relevant national and local guidelines
and accident prevention regulations. This applies especially to guidelines regard-
ing the risks arising during transport.
After transporting the device, the device must be visually inspected for damage
before commissioning. Any damage must be repaired by trained service techni-
cians before commissioning the device.
Safety measures Only operate the device when all safety devices are fully functional. If the safety
in normal opera- devices are not fully functional, there is a risk of
tion
-
-
-
Any safety devices that are not functioning properly must be repaired before
switching on the device.
Never bypass or disable safety devices.
Before switching on the device, ensure that no one is likely to be endangered.
Check the device at least once a week for obvious damage and proper function-
ing of safety devices.
-
-
-
-
-
Commissioning,
It is impossible to guarantee that bought-in parts are designed and manufac-
maintenance and tured to meet the demands made of them, or that they satisfy safety require-
repair ments.
-
-
-
-
The housing screws provide the ground conductor connection for earthing the
housing parts.
Only use original housing screws in the correct number and tightened to the spe-
cified torque.
10
injury or death to the operator or a third party,
damage to the device and other material assets belonging to the operator,
inefficient operation of the device.
Only use suitable original parting agent from the manufacturer.
Observe the information on the parting agent safety data sheets when hand-
ling parting agent. The parting agent safety data sheets may be obtained
from your service centre or downloaded from the manufacturer's website.
Do not mix the manufacturer's parting agent with other parting agents.
If damage results from using a different parting agent, the manufacturer ac-
cepts no liability. In addition, no warranty claims will be entertained.
Used parting agent must be disposed of properly in accordance with the rel-
evant national and international regulations.
Use only original spare and wearing parts (also applies to standard parts).
Do not carry out any modifications, alterations, etc. to the device without the
manufacturer's consent.
Components that are not in perfect condition must be replaced immediately.
When ordering, please give the exact designation and part number as shown
in the spare parts list, as well as the serial number of your device.