Fronius Robacta TC 2000 Operating Instructions Manual page 51

(1)
Move the welding torch to the start position above the cleaning opening - ap-
3
proximately 50 mm (1.97 in.) centrally above the middle of the cleaning open-
ing
- The cleaning operation is complete and the welding torch is ready for use
again
Ensure that not too much parting agent has accumulated on the gas nozzle
4
(no droplet formation). If this is the case :
- Reduce the spray time or
- After the cleaning operation, blow out the welding torch with com-
pressed air using the hosepack
Place the welding torch in the
1
spray position
- see figure
NOTE!
During the spraying process, ensure
that compressed air is not blown out
through the welding torch.
Spray welding torch with parting
2
agent for approximately 0.7
seconds
51