Safety Measures In Normal Operation; Maintenance And Repair - Fronius Artis 170 Operating Instructions Manual

It is essential to conduct a visual inspection of the device to check for damage
after it has been transported but before commissioning. Have any damage re-
paired by trained service technicians before commissioning the device.
Safety Measures Only operate the device when all safety devices are fully functional. If the safety
in Normal Oper- devices are not fully functional, there is a danger of:
ation -
-
-
Safety devices that are not fully functional must be repaired before the device is
switched on.
Never bypass or disable safety devices.
Before switching on the device, ensure that no one can be put in danger.
The device must be examined at least once a week for externally detectable dam-
age and functionality of the safety devices.
Always secure the shielding gas cylinder well and remove before transporting by
crane.
Only the original coolant from the manufacturer is suitable for use in our devices
due to its properties (electrical conductivity, anti-freeze, material compatibility,
flammability, etc.)
Only use appropriate original coolant from the manufacturer.
Do not mix original coolant from the manufacturer with other coolants.
Only connect system components from the manufacturer to the cooling unit cir-
cuit.
If there is damage due to use of other system components or other coolants, the
manufacturer accepts no liability for this and all warranty claims are forfeited.
Cooling Liquid FCL 10/20 is not flammable. The ethanol-based coolant is flam-
mable in certain conditions. Only transport the coolant in closed original contain-
ers and keep away from sources of ignition.
Properly dispose of used coolant according to national and international regula-
tions. The coolant safety data sheet can be obtained from your service center or
via the manufacturer's website.
When the system is cool, always check the coolant level before starting welding.
Maintenance and It is impossible to guarantee that bought-in parts are designed and manufac-
repair
tured to meet the demands made of them, or that they satisfy safety require-
ments.
-
-
-
-
The housing screws provide the ground conductor connection for earthing the
housing parts.
Injury or death to the operator or a third party
Damage to the device and other material assets belonging to the operating
company
Inefficient operation of the device
Use only original spare and wearing parts (also applies to standard parts).
Do not carry out any modifications, alterations, etc. to the device without the
manufacturer's consent.
Components that are not in perfect condition must be replaced immediately.
When ordering, please give the exact designation and part number as shown
in the spare parts list, as well as the serial number of your device.
15