Troubleshooting - Fronius Robacta TC 2000 Operating Instructions Manual

Troubleshooting

Troubleshooting Make a note of the serial number and configuration of the device and contact our
After-Sales Service team with a detailed description of the error, if
-
-
Mains voltage indicator not lit
Mains cable connected
Cause:
Remedy:
"Ready-to-clean" signal not transmitted to robot control
Mains voltage indicator lit
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Ready-to-clean signal not transmitted to robot control
Mains voltage indicator lit, overtemperature indicator lit
Cause:
Remedy:
Fill level indicator lit
The liquid in the dipping bowl is below the optimum fill level
Cause:
Remedy:
Fill level indicator lit
The "Robacta TC Cool / Robacta TC Cool MD" parting agent container is not yet
empty
Cause:
Remedy:
Cause:
Remedy:
errors occur that are not listed below
the troubleshooting measures listed are unsuccessful
Faulty mains cable
Check mains cable
Quick Stop is active (HI - Quick Stop = LO / LO - Quick Stop =HI)
Deactivate Quick Stop (HI - Quick Stop = HI / LO - Quick Stop =LO)
Supply to I/O standard connection socket (X1) is faulty
Depending on the connection socket, check the assignment of inputs
"B" and "H" / "D" and "G"
Temperature sensor is faulty
Change cleaning coil
The cleaning device is overheating
Allow cleaning device to cool down. Once the permitted operating
temperature has been reached, charging of the capacitors starts
again. The cleaning device is then ready to clean again
"Robacta TC Cool / Robacta TC Cool MD" parting agent container is
empty
Replace "Robacta TC Cool / Robacta TC Cool MD" parting agent con-
tainer
Level sensor is dirty
Clean level sensor with fresh water
Level sensor faulty
Contact After-Sales Service
63