Installing the main unit using a wall-mount bracket
To install your BCM450 system on a wall, you must install a wall-mount bracket
for the main unit and optional expansion cabinet.
Prerequisites
•
Obtain five #8 x 2 cm (#8 x 0.75 in.) round-head wood screws to attach the
wall-mount bracket to the backboard (or wall).
•
Obtain tools for the installation including a screwdriver (for the wood
screws), a level, and a pencil.
Procedure steps
Step
1
2
3
4
5
6
7
8
9
Copyright © 2006-2009 Nortel Networks
Action
Place the wall-mount bracket on the backboard (or wall) and mark the
location of the screw holes. Use a bubble level to ensure that the wall-mount
bracket is level with the plywood backboard.
Install four #10 x 2.5 cm (#10 x 1 in.) round-head screws in the backboard.
Leave approximately 0.5 cm (0.25 in.) of each screw exposed from the
backboard (or wall).
Hang the wall-mount bracket on the installed screws.
Use a level to make sure the wall-mount bracket is level.
Remove the wall-mount bracket from the backboard.
Align the screw holes on one side of the BCM450 main unit with the wall-
mount bracket.
Fasten the wall-mount brackets securely to the BCM450 main unit by using
the screws provided.
Hang the BCM main unit on the backboard screws. Make sure the main unit
is level. Ensure the wood screw heads seat fully into the wall-mount bracket
slots.
Tighten the wood screws against the wall-mount bracket.
Nortel Business Communications Manager 450 1.0
Installation — System
NN40160-301 01.04 Standard
July 2009
BCM450 main unit wall-mount installation 33
--End--
--End--