Bcm450 Common Procedures; Rebooting The Bcm450 - Nortel Business Communications Manager 450 Installation Manual

BCM450 common procedures

This chapter describes common procedures for the BCM450 system.
BCM450 common procedures navigation
• Rebooting the BCM450 (page 95)
• BCM450 shut-down (page 96)
• Installation troubleshooting (page 96)

Rebooting the BCM450

You can reboot the BCM450 system through Element Manager. For
information to install Element Manager, see
(page
Prerequisites
• Element Manager must be installed on a PC connected to the BCM450
system, either through the LAN, soft modem, ISDN, or directly through the
OAM port.
Step
1
2
3
4
5
Copyright © 2006-2009 Nortel Networks
91).
Action
Check for a recent backup of the BCM450 system programming.
If no recent backup is available, use Element Manager to back up the
system data. For information about backing up the system data, see Nortel
Business Communication Manager 450 1.0—Administration and Security
(NN40160-601).
From the Administration tab, click the Utilities folder to expand it.
From the Utilities folder, select Reset.
Click Reboot BCM450 System to reboot the system.
Nortel Business Communications Manager 450 1.0
Installation — System
NN40160-301 01.04 Standard
July 2009
Element Manager installation
--End--