Configuring Mbms For Expansion Cabinet Installation - Nortel Business Communications Manager 450 Installation Manual

2
3
4
5
6
7

Configuring MBMs for expansion cabinet installation

Before installing an MBM in the expansion cabinet, configure it through
Element Manager and set the DIP switches.
Procedure steps
Step
1
2
3
4
5
6
7
8
Copyright © 2006-2009 Nortel Networks
Choose the MBM bay (i.e. Main 1) that you want to configure.
Under Configured Device, select the type of MBM you want to install.
Press Configure.
Enter the Start DN, Public received digits/OLI, Private received digits/
OLI, and Start Line depending on the type of MBM.
Select or leave clear the Assign target lines check box.
Repeat for each media bay module you want to install.
Action
In Element Manager, navigate to Configuration > Resources > Telephony
Resources.
Select Expansion 1 from the table. A menu appears.
Choose the MBM bay (i.e. Expansion 1.1) that you want to configure.
Under Configured Device, select the type of MBM you want to install.
Press Configure.
Enter the Start DN, Public received digits/OLI, Private received digits/OLI,
and Start Line depending on the type of MBM.
Select or leave clear the Assign target lines check box.
Locate the DIP switches at the rear or underside of the MBM.
Nortel Business Communications Manager 450 1.0
Installation — System
NN40160-301 01.04 Standard
July 2009
--End--
MBM installation 51