Procedure Steps; Mounting The Ata2 To A Wall - Nortel Business Communications Manager 450 Installation Manual

Procedure steps

Step
1
2
3
4
5
6

Mounting the ATA2 to a wall

After you connect the ATA2, you can mount it on a wall.
Prerequisites
• You require 2 4-mm (#8) screws.
• When using 0.5mm wire (24 AWG), select a location within 800 m (2600
ft.) of the BCM450 main unit.
• Allow 12.5 cm (5 in.) clearance for the line jack, terminal jack, and power
supply connector.
Procedure steps
Step
1
2
Copyright © 2006-2009 Nortel Networks
Action
Connect one end of a line cord to the ATA2 terminal jack.
Connect the other of the line cord to your telephone, modem, or fax
machine.
Connect one end of a line cord to the ATA2 line jack.
Connect the other end of the line cord to an available digital station port.
For a 120 V or 230 V system, plug the DIN connector of the power supply
cord into the power supply connector receptacle.
Plug the adapter into a standard AC outlet.
Action
Screw two 4-mm (#8) screws into the wall, 130 mm (5 1/4 in.) away from
each other. Leave 6 mm (1/4 in.) of the two screws showing.
Align the slots at the back of the ATA2 unit over the screws. Push the unit
against the wall. The line jack, terminal jack, and power supply connector
must be at the top of the ATA2.
Nortel Business Communications Manager 450 1.0
Installation — System
NN40160-301 01.04 Standard
July 2009
Analog terminal adapter installation 87
--End--
--End--