Installing The Expansion Cabinet On A Desktop - Nortel Business Communications Manager 450 Installation Manual

40 BCM450 expansion cabinet installation
2
3
4
5
6
7
8
9

Installing the expansion cabinet on a desktop

If you cannot install your BCM450 expansion cabinet in an equipment rack or
on a wall, you can install your expansion cabinet on a desktop or shelf.
Prerequisites
• Locate the four self-adhesive rubber feet.
• Leave enough space around the expansion cabinet for ventilation and
access to the cables.
Procedure steps
Step
1
2
3
Connecting the expansion cabinet to the main unit
Connect the expansion cabinet to the main unit to gain additional functionality
provided by the MBMs.
Copyright © 2006-2009 Nortel Networks
Install four #10 x 2.5 cm (#10 x 1 in.) round-head screws in the backboard.
Leave approximately 0.5 cm (0.25 in.) of each screw exposed from the
backboard (or wall).
Hang the wall-mount bracket on the installed screws.
Use a level to make sure the wall-mount bracket is level.
Remove the wall-mount bracket from the backboard.
Align the screw holes on one side of the BCM450 expansion cabinet with
the wall-mount bracket.
Fasten the wall-mount brackets securely to the BCM450 expansion cabinet
using the screws provided.
Hang the expansion cabinet on the backboard screws. Make sure the
expansion cabinet is level. Ensure the wood screw heads seat fully into the
wall-mount bracket slots.
Tighten the wood screws against the wall-mount bracket.
Action
Remove the paper backing from the four enclosed self-adhesive rubber feet.
Attach the four self-adhesive rubber feet to the bottom of the expansion
cabinet.
Position the expansion cabinet on a desktop or shelf.
Nortel Business Communications Manager 450 1.0
Installation — System
NN40160-301 01.04 Standard
July 2009
--End--
--End--