10 Gbps Ethernet Port; Flexible Interface Platform Modules - H3C SR6602-X1 AC Installation Manual

NOTE:
• Use transceiver modules for the fiber ports provided by H3C only. The router might be
incompatible with transceiver modules from other vendors. The system generates an alarm when
a transceiver module from another vendor is installed.
• The BIDI modules must be used in pairs. For example, if you install the
SFP-GE-LX-SM1310-BIDI in the local port, you must install the SFP-GE-LX-SM1490-BIDI in the
peer port.

10 Gbps Ethernet port

The SR6602-X2 provides two 10 Gbps Ethernet ports. 10 Gbps SFP+ ports do not support 1000
Mbps transceiver modules.
Table 37 10 Gbps Ethernet port specifications
Item
Protocol
Connector type
Transceiver module type
Physical layer
Transmission rate
Table 38 Transceiver modules for the SFP+ ports
Model
SFP-XG-SX-MM850-
A
SFP-XG-SX-MM850-
E
SFP-XG-LX-SM1310
SFP-XG-LX-SM1310
-E
SFP-XG-LH40-SM15
50
SFP-XG-LH80-SM15
50

Flexible interface platform modules

The SR6602-X Router Series supports flexible interface platform (FIP) modules FIP-10 and FIP-20.
You can install High-speed Interface Modules (HIMs) and Multifunctional Interface Modules (MIMs)
on a FIP to support different network services as needed. A FIP module is located on the lower part
of the front panel.
Specification
802.3ae
LC
SFP+
10GBASE-R/W
•
LAN PHY—10.3125 Gbps
•
WAN PHY—9.95328 Gbps
Central Connector
wavelength type
850 nm LC
850 nm LC
1310 nm LC
1310 nm LC
1550 nm LC
1550 nm LC
78
Fiber type
50/125µm multi-mode
50/125µm multi-mode
9/125µm single mode
9/125µm single mode
9/125µm single mode
9/125µm single mode
Max.
transmission
distance
300 m (984.25 ft)
300 m (984.25 ft)
10 km (6.21 miles)
10 km (6.21 miles)
40 km (24.86 miles)
80 km (49.71 miles)