Making An Ethernet Cable - H3C SR6602-X1 AC Installation Manual

Table 8 Straight-through cable pinouts
Pinout No.
1
2
3
4
5
6
7
8
Table 9 Crossover cable pinouts
Pinout No.
1
2
3
4
5
6
7
8
NOTE:
Strictly follow the pinouts in the above tables when identifying or making the two types of Ethernet
cables; otherwise, the communication quality may be affected.

Making an Ethernet cable

Cut the cable to a proper length with the crimping pliers.
1.
Strip off an appropriate length of the cable sheath. The length is typically that of the RJ-45
2.
connector.
Untwist the pairs so that they can lay flat, and arrange the colored wires based on the wiring
3.
specifications.
Cut the top of the wires even with one another. Insert the wires into the RJ-45 end and make
4.
sure the wires extend to the front of the RJ-45 end and make good contact with the metal
contacts in the RJ-45 end and in the correct order.
Crimp the RJ-45 connector with the crimping pliers until you hear a click.
5.
Use a cable tester to verify the proper connectivity of the cable.
6.
A
Orange/white
Orange
Green/white
Blue
Blue/white
Green
Brown/white
Brown
A
Orange/white
Orange
Green/white
Blue
Blue/white
Green
Brown/white
Brown
20
B
Orange/white
Orange
Green/white
Blue
Blue/white
Green
Brown/white
Brown
B
Green/white
Green
Orange/white
Blue
Blue/white
Orange
Brown/white
Brown