Rebooting The Router - H3C SR6602-X1 AC Installation Manual

Table 20 To save the current configuration of the router:
Purpose
Save the current configuration to the specified file, but the
configuration file will not be set as the file for the next startup
Save the current configuration to the root directory of the storage
medium of the active or standby MPU and specify the file as the
startup configuration file that will be used at the next system startup
NOTE:
• The configuration file must be with extension .cfg.
• During the execution of the save command, the startup configuration file to be used at the next
system startup may be lost if the router reboots or the power supply fails. In this case, the router
will boot with the factory defaults, and after the router reboots, you need to re-specify a startup
configuration file for the next system startup.

Rebooting the router

When upgrading and maintaining the startup configuration file or configuration file for the router, you
need to reboot the router. To reboot a router, use one of the following methods:
•
Use the reboot command to reboot a router.
•
Enable the scheduled reboot function at the CLI. You can set a time at which the router can
automatically reboot, or set a delay so that the router can automatically reboot within the delay.
•
Power on the router after powering it off, which is also called hard reboot or cold start. Powering
off a running router causes data loss and hardware damages, and therefore is not
recommended.
•
Use the RESET button.
To reboot the router immediately:
Purpose
Reboot the router immediately
To enable the scheduled reboot function:
Purpose
Enable the scheduled reboot
function and specify a specific
reboot time and date
Enable the scheduled reboot
function and specify a reboot
waiting time
Command
reboot
Command
schedule reboot at hh:mm
[ date ]
schedule reboot delay { hh:mm |
mm }
56
Command Remarks
save file-url Use either
command
Available in any
save [ safely ]
view
Remarks
Required
Available in user view
Remarks
Use either command
The scheduled reboot function is
disabled by default.
Available in user view