Connecting The Grounding Cable - H3C SR6602-X1 AC Installation Manual

To install the ring terminal:
Cut the grounding cable as appropriate for connecting to the grounding strip, and strip 5 mm
1.
(0.20 in) of insulation sheath by using a wire stripper.
Insert the bare metal part through the black insulation covering into the end of the ring terminal.
2.
Crimp the metal part of the cable to the ring terminal with a crimper.
3.
Cover the joint with the insulation covering, and heat the insulation covering with a blow dryer to
4.
completely cover the metal part.
Figure 9 Installing the ring terminal

Connecting the grounding cable

Remove the grounding screw from the rear panel of the router chassis.
1.
Attach the grounding screw to the ring terminal of the grounding cable.
2.
Use a screwdriver to fasten the grounding screw into the grounding screw hole.
3.
Attach the ring terminal on the other end of the grounding cable to the grounding strip.
4.
11