Table of Contents
Advertisement
Connecting an Ethernet cable
Plug one end of an Ethernet twisted pair cable into the copper Ethernet port (RJ-45 port) to be
1.
connected on the router and the other end of the cable into the Ethernet port of the peer device.
The 10/100/1000Base-T copper ports of the router support MDI/MDI-X auto-sensing. They are
connected to the network through category-5 or above twisted pairs that are equipped with
RJ-45 connectors.
Check the status LED of the Ethernet ports. For more information about the LED status, see
2.
"Appendix B
Connecting a fiber cable
Transceiver module overview
When you use a fiber port, you need an SFP, XFP, or SFP+ transceiver module and a fiber cable with
an LC connector.
•
SFP transceiver module—Applicable to 100/1000 Mbps Ethernet fiber ports and SFP ports on
some HIMs.
•
XFP transceiver module—Applicable to XFP ports on the HIM-1EXP.
•
SFP+ transceiver module—Applicable to GE SFP+ ports on the SR6602-X2.
Figure 23 SFP transceiver module
Figure 24 XFP transceiver module
LEDs."
21
Advertisement
Table of Contents
