Table of Contents
Advertisement
Figure 1 Airflow (SR6602-X1)
•
Make sure there is enough space (greater than 10 cm (3.94 in)) around the air intake and outlet
vents on the router for good ventilation.
•
Make sure the installation site has a good cooling system.
ESD prevention
CAUTION:
• Check the resistance of the ESD wrist strap for safety. The resistance reading should be in the
range of 1 to 10 megohm (Mohm) between human body and the ground.
• The SR6602-X does not provide any ESD wrist strap. Prepare it yourself.
To prevent electrostatic discharge (ESD), note the following guidelines:
•
Make sure the router and rack are well grounded.
•
An anti-static floor is installed and well grounded.
•
Maintain the humidity and temperature at a proper level in the equipment room. For more
information, see
•
Always wear an ESD wrist strap and ESD cloth when touching a circuit board, interface module,
or transceiver module.
•
Place the removed memory module, CF card, FIP, HIM, or MIM on an antistatic workbench, with
the face upward, or put it into an antistatic bag.
•
Touch only the edges, instead of electronic components when observing or moving a removed
memory module, CF card, HIM, or MIM.
To use the ESD wrist strap, perform the following steps:
Wear the wrist strap on your wrist.
1.
Lock the wrist strap tight around your wrist to keep good contact with the skin.
2.
Attach the ESD wrist strap to the alligator clips.
3.
Attach the alligator clips to the rack post.
4.
Make sure the rack is well grounded.
5.
"Temperature and
humidity."
4
Advertisement
Table of Contents
