Appendix C Repackaging The Router; Removing Cables From The Router; Removing The Power Cord; Removing The Console Cable - H3C CR16000-F Installation Manual

Appendix C Repackaging the router

This chapter describes how to repackage the router chassis, power supply, card, mounting bracket,
cable management bracket, and air filter.

Removing cables from the router

Before repackaging the router, remove all cables such as the power cord, console cable, twisted pair,
optical fiber, and grounding cable from the router.

Removing the power cord

1. Switch off the circuit breakers at the input end of all power cords.
2. Wear an ESD wrist strap, and make sure it has a good skin contact and is correctly grounded.
For more information, see "Attaching an ESD wrist strap."
3. Remove the power cord plug:
AC power cord—Remove the cable tie that secures the power cord, and then pull out the

plug.
DC power cord—Remove the cable tie that secures the power cord, loosen the fastening

screw on the power cord, and then pull out the plug.

Removing the console cable

1. Pull the RJ-45 connector of the console cable out from the console port of the router.
2. Pull the DB-9 connector of the console cable out from the serial port of the PC.

Removing the grounding cable

1. Loosen the two screws at the grounding holes of the chassis, and then remove the grounding
cable from the chassis.
2. Use a lever to loosen the hex nut on the grounding post of the grounding strip, and remove the
other end of the grounding cable (with a ring terminal) from the grounding post.
1