Operation Of The Manual Engine Speed Setting Mode - Kubota M7132 Operator's Manual

OPERATING THE TRACTOR
Ez-command centre operation (for example: plough
work)
1. Set a desired travelling speed with the ez-command
centre, and the engine power is controlled to keep
up this speed.
2. Step on the both brake pedals to stop the tractor.
When releasing the pedals to start, the travelling
speed must be reset. When stopped with the clutch
pedal, you can drive at the pre-set travelling speed
when you release the clutch pedal.
(1) Ez-command centre
(2) Foot throttle
(3) Hand throttle
3. Operation of the manual engine
speed setting mode
This mode mainly serves for PTO-driven implements
like harvesters.
The optimum travelling speed and engine power are
obtained according to the engine rpm setting made with
the hand throttle, and CVT sensitivity settings.
(See Setting the continuously variable transmission
(CVT) sensitivity on page 175.)
Switching to the manual engine speed setting
mode
1. Set the shuttle lever to neutral. Or press the shuttle
neutral button.
2. Accelerate the engine using the hand throttle, and
the manual engine speed setting mode is selected.
Operation
1. Select the PTO shaft rpm and travelling speed
according to the implement in question.
2. Even if the load is increased or decreased, a
constant PTO shaft rpm is kept up.
3. Needless to say, towed implements without any
PTO shaft rotation may also be used in this mode.
174
CONTINUOUSLY VARIABLE TRANSMISSION (CVT) CONTROL
(A) With "AUTOMATIC" mode
selected
(B) With "manual engine speed
setting" mode selected
M7132, M7152, M7172