Kubota M7132 Operator's Manual page 193

HEADLAND MANAGEMENT SYSTEM
(1) Headland management system lock indicator
(2) Program code display indicator
(3) Headland management system lock and unlock switch
(4) Program select switch
NOTE :
• The headland management system is kept
locked all the time when the engine gets
started. To enable this system, press the
headland management system lock and unlock
switch to unlock it.
• While the program is being executed, the
manually operated levers and switches can be
used. If the opposite operation takes place
while the program is running, however, the
program run is interrupted.
For example, the program is interrupted if the 3-
point quick lower switch is used and then the 3-
point quick raise switch is pressed.
• Before turning on the PTO shaft, use the PTO
gear shift lever to select the PTO shaft speed
(540 or 1000 rpm) in advance.
• Before using the remote control valves, set the
remote control valve switch to the neutral
position.
• Work can also be started, pressing the "Field
in" button as the first step.
Field in and out buttons
When the indicators of both buttons are on, press either
of the buttons to activate the headland management
system.
M7132, M7152, M7172
With the headland
management sys-
tem lock/unlock Indicators of both buttons: "OFF"
switch at lock posi-
tion
With the headland
management sys-
Indicators of both buttons: "ON"
tem program ready
to run
With the field out
button pressed and Indicator of field out button: "ON"
the program run- Indicator of field in button: "OFF"
ning
(1) Field out button
(2) Field in button
(3) Indicator
OPERATING THE TRACTOR
187