Preparation Before Testing; Testing Engine Start System; Testing Transmission (Neutral) Control; Testing Hydraulic Up/Down (Lock) Control - Kubota M7132 Operator's Manual

PERIODIC SERVICE
• If the tractor does not pass the test, do not
operate the tractor.

1.1 Preparation before testing

1. Place all control levers in the "NEUTRAL" position.
2. Set the handbrake, stop the engine and lower all
implements.

1.2 Testing engine start system

(1) Shuttle lever
(2) Clutch pedal
(3) Liquid crystal display
1. Follow the instructions about parking the tractor.
(See PARKING THE TRACTOR on page 16.)
2. Sit on the operator's seat.
3. Depress the clutch pedal fully.
4. Turn the key to "START" position.
5. The engine must crank.
6. If it does not crank, consult your local KUBOTA
Dealer for this service.

1.3 Testing transmission (neutral) control

(1) Shuttle lever
(2) Clutch pedal
(3) Liquid crystal display
262
1. Follow the instructions about parking the tractor.
(See PARKING THE TRACTOR on page 16.)
2. Sit on the operator's seat.
3. Depress the clutch pedal fully.
4. Start the engine.
5. Check to see if the shuttle shift is held in their
neutral position.
6. If not, consult your local KUBOTA Dealer for this
service.
1.4 Testing hydraulic up/down (lock)
control
Standard model
(1) Parking/secondary brake lever
(2) 3-P quick raise and lower switch
(3) Depth control dial
(4) 3-point hitch lock button
Premium, Premium KVT models
(1) Parking/secondary brake lever
(2) 3-P quick raise and lower switch
(3) Depth control dial
(4) 3-point hitch lock button
1. Follow the instructions about parking the tractor.
(See PARKING THE TRACTOR on page 16.)
2. Sit on the operator's seat.
3. Depress the clutch pedal fully.
4. Start the engine.
EVERY 50 HOURS
M7132, M7152, M7172