Table of Contents
Advertisement
124
OPERATING THE TRACTOR
BOperation of the Automatic Mode
This mode is mainly utilized for traveling on public roads
and towing plows and similar implements.
The optimum traveling speed and engine power are
obtained according to the speed settings made with the
ez-command center or foot throttle as well as the setting
made in "Setting the CVT (Continuously Variable
Transmission) sensitivity" discussed later.
(In this mode, the engine rpm also fluctuates with changes
in load. Therefore this mode is not suited for PTO-driven
operations.)
C Switching to the automatic mode
1. Set the shuttle lever to neutral. Or press the shuttle
neutral button.
2. Set the hand throttle close to "Minimum speed", and
the automatic mode is selected.
(Even during operation, do not move the hand
throttle.)
C Foot throttle operation (ex.Trailer work)
1. You can control both the speed and the engine power
by how deeply you step on the foot throttle, as with an
automatic transmission car.
2. Release your foot from the foot throttle pedal, and the
machine slows down.
3. To bring the machine to a complete halt, step on the
brake pedal. When you release the brake pedal, the
tractor starts running.
C Ez-command center operation (ex.Plow work)
1. Set a desired traveling speed with the ez-command
center, and the engine power is controlled to keep up
this speed.
2. Step on the both brake pedals to stop the tractor.
When release the pedals to start, the traveling speed
must be reset. When stopped with the clutch pedal,
you can drive at the preset traveling speed when you
release the clutch pedal.
(1) Ez-command center
(2) Foot throttle
(3) Hand throttle
BOperation of the Manual Engine Speed
Setting Mode
This mode mainly serves for PTO-driven implements like
harvesters.
The optimum traveling speed and engine power are
obtained according to the engine rpm setting made with
the hand throttle as well as the setting made in "Setting
the CVT (Continuously Variable Transmission) sensitivity"
discussed later.
C Switching to the manual engine speed setting
mode
1. Set the shuttle lever to neutral. Or press the shuttle
neutral button.
2. Accelerate the engine using the hand throttle, and the
manual engine speed setting mode is selected.
C Operation
1. Select the PTO shaft rpm and traveling speed
according to the implement in question.
2. Even if the load is increased or decreased, a constant
PTO shaft rpm is kept up.
3. Needless to say, towed implements without any PTO
shaft rotation may also be used in this mode.
(A) With "AUTOMATIC"
mode selected
(B) With "Manual Engine
Speed Setting" mode
selected
Hide quick links:
Advertisement
Table of Contents
