Tyres, Wheels And Ballast; Tyres; Inflation Pressure; Jack Point - Kubota M7132 Operator's Manual

TYRES

TYRES, WHEELS AND BALLAST

TYRES
WARNING
To avoid personal injury or death:
• Do not attempt to mount a tyre on a rim. This
should be done by a qualified person with the
proper equipment.
• Always maintain the correct tyre pressure.
Do not inflate tyres above the recommended
pressure shown in the operator's manual.
IMPORTANT :
• Do not use tyres other than those approved by
KUBOTA.

1. Inflation pressure

Although the tyre pressure is factory-set to the
prescribed level, it naturally drops slowly in the course
of time. Thus, check it every day and inflate as
necessary.
NOTE :
• Maintain the maximum pressure in front tyres if
using a front loader or when equipped with a
full load of front weights.
• When retrofitting the tractor with other tire
combinations such as those described above or
with special purpose tires, consult your local
KUBOTA Dealer to get information regarding
permitted tyre combinations, tire pressure and
additional information.
Tyre sizes
380/85R28
420/70R28
Front 420/85R28
480/70R28
540/65R28
460/85R38
520/70R38
Rear 520/85R38
580/70R38
650/65R38
M7132, M7152, M7172
Inflation pressure
2
160 kPa (1.6 kgf/cm )
2
160 kPa (1.6 kgf/cm )
2
160 kPa (1.6 kgf/cm )
2
160 kPa (1.6 kgf/cm )
2
160 kPa (1.6 kgf/cm )
2
160 kPa (1.6 kgf/cm )
2
160 kPa (1.6 kgf/cm )
2
160 kPa (1.6 kgf/cm )
2
160 kPa (1.6 kgf/cm )
2
160 kPa (1.6 kgf/cm )
TYRES, WHEELS AND BALLAST

2. Jack point

WARNING
To avoid personal injury or death:
• Before jacking up the tractor, park it on a firm
and level ground and chock the front wheels.
• Fix the front axle to keep it from pivoting.
• Select jacks that withstand the machine weight
and set them up as follows.
When using a jack, be sure to set the jack at the
position indicated on the label and illustration.
If the jack is positioned incorrectly, it may damage the
tractor.
(1) Label
(1) Jack point
231