Patient Table; Control System - Philips CARDIOMD Service Manual

I, II Tower top cover
X drive
slide cover
X drive cover
Figure 2.3 CardioMD covers – series I and II systems
2.2.1.3

Patient Table

The table console supports the patient table pallet. The table pallet is supported at the other end by
a roller system allowing for longitudinal movement of the pallet.
The pallet is made of a 3 mm aluminum plate and will attenuate approximately 10 % of the counts
at 140 keV. The pallet comes in two versions:
•
In one configuration, the length of the table pallet length is 280 cm. This configuration
supports both prone and supine imaging.
•
For small room installations, a shortened table (200 cm) for supine imaging only is provided.
The capacity of both table versions is 400 lbs. (180 kg).
The height of the table is fixed. The table can be moved along its longitudinal axis by means of a
motor controlled from the CardioMD hand controller. This motion is intended for fine tuning of
the patient's position relative to the detectors. There is no manual movement as part of normal
operation.
2.2.1.4

Control System

CardioMD can be controlled both from the acquisition PC and from the hand controller.
1MAN0158-H11 04-2005 CSIP Level 1
Tower side cover
Rotate gear cover
Detector 1
Gantry base cover Detector side cover
CardioMD Service Manual 2-5
System Overview
Detector top cover
Detector side cover
Table console
front cover
Table console
rear cover