Installing The Service Access Cover On The 8231-E2B, 8231-E1C, 8231-E1D, 8231-E2C, 8231-E2D, Or 8268-E1D; Placing The Rack-Mounted 8231-E2B, 8231-E1C, 8231-E1D, 8231-E2C, 8231-E2D, Or 8268-E1D System Into The Service Position Or Operating Position; Placing The Rack-Mounted 8231-E2B, 8231-E1C, 8231-E1D, 8231-E2C, 8231-E2D, Or 8268-E1D Into The Service Position - IBM 8231-E2B Manual

Installing the service access cover on the 8231-E2B, 8231-E1C,
8231-E1D, 8231-E2C, 8231-E2D, or 8268-E1D
Use this procedure to install the service access cover.
Perform the following steps to install the service access cover:
1. Place the service access cover (A) on top of the system, about 25 mm (1 in.) from the upper chassis
ledge.
2. Hold the service access cover against the system unit and slide it toward the front of the system. The
tabs of the service access cover slide beneath the upper chassis ledge.
3. Align the thumbscrew (B) located on the rear of the service access cover with the two holes on the
rear of the system chassis.
4. Tighten the thumbscrews to secure the service access cover.
Figure 29. Installing the service access cover
Placing the rack-mounted 8231-E2B, 8231-E1C, 8231-E1D, 8231-E2C,
8231-E2D, or 8268-E1D system into the service position or operating
position
Use these procedures to place a system into the service position or operating position to perform service
or to gain access to internal components.
Placing the rack-mounted 8231-E2B, 8231-E1C, 8231-E1D, 8231-E2C,
8231-E2D, or 8268-E1D into the service position
Use this procedure to place the rack-mounted system into the service position.
Notes:
Common procedures for installable features
47