Table of Contents
Advertisement
GE M
S
EDICAL
YSTEMS
D
FC091194, R
IRECTION
3-9-3
Connectivity Setup
NOTE:
If connected as a stand-alone network (only scanner, EchoPAC PC work station and eventually
a network printer in a separate network), you should use default delivery settings.
3-9-3-1
Introduction
To be able to use the network functions when connected to a hospital network, the scanner must have
a proper network address.
•
Before you can set up the scanner, you need to collect some information. The
DICOM Network Information" on page 2-11
source for this information is the network administrator.
•
Follow the steps below to prepare the scanner for use on the network.
3-9-3-2
Select TCP/IP Set-up Screen
1.) Press CONFIG on the Control Panel and log on as adm (see
02
EVISION
Figure 3-34 Measuring and Analyzes - Global Level
Chapter 3 - Installation
V
7 / V
IVID
can be used for gathering this information. Typically
page
18).
7 PRO S
M
IVID
ERVICE
ANUAL
"Worksheet for
Connectivity
3 - 37
Advertisement
Table of Contents
