Table of Contents
Advertisement
GE M
S
EDICAL
YSTEMS
D
FC091194, R
IRECTION
1-3-3
Mechanical Safety (cont'd)
VIVID 7 / VIVID 7 PRO weighs 190 kg (419 lbs) or more, depending on installed peripherals, when
CAUTION
ready for use. Care must be used when moving it or replacing its parts. Failure to follow the
precautions listed below could result in injury, uncontrolled motion and costly damage.
Do not transport Vivid 7 / Vivid 7 PRO in a vehicle without locking the casters (wheels).
CAUTION
ALWAYS:
-
- Be sure the pathway is clear.
- Use slow, careful motions.
- Use two people when moving on inclines or lifting more than 23 kg (50 lbs).
NOTE:
Special care should be taken when transporting the unit in a vehicle:
•
Lock keyboard in place.
•
Eject Magneto Optical disk from the MO Drive (if installed).
•
Eject CD from CD drive.
•
Secure the unit in an upright position.
•
Lock the casters (wheels) (brake)
•
DO NOT use the Control Panel as an anchor point.
•
Place the probes in their carrying case.
Keep the heat venting holes on the monitor unobstructed to avoid overheating of the monitor.
CAUTION
1-3-4
Electrical Safety
1-3-4-1
Safe Practices
Follow these guidelines to minimize shock hazards whenever you are using the scanner;
•
The equipment chassis must be connected to an electrical ground.
•
The unit is equipped with a three-conductor AC power cable. This must be plugged into an approved
electrical outlet with safety ground.
•
The power outlet used for this equipment should not be shared with other types of equipment.
•
Both the system power cable and the power connector must meet international electrical standards.
1-3-4-2
Probes
Follow these guidelines before connecting a probe to the scanner;
•
Inspect the probe prior to each use for damage or degradation to the;
-
-
-
-
•
Do not use a damaged or defective probe.
02
EVISION
housing
cable strain relief
lens
seal
Chapter 1 - Introduction
V
7 / V
7 PRO S
IVID
IVID
ERVICE
M
ANUAL
1 - 13
Advertisement
Table of Contents
