Composition Of Peripheral Equipments - Panasonic MINAS A6N Series Operating Instructions Manual

2
Preparation
接続例（A 〜 B 枠 100 V/200 V の場合）
Connecting Example of A to B-frame (100 V/200 V Type)
Mains and Residual current device (RCD)
Apply the voltage designated on the
nameplate from the power source.
Circuit Breaker (MCCB)
To protect power supply line from overload-
ing, install a wiring circuit breaker rated to the
capacity of the power supply.
Noise Filter (NF)
Removes external noise from the power
lines. And reduces an effect of the noise
generated by the servo driver.
Magnetic Contactor (MC)
Turns on/off the main power of the servo
driver.
Use coil surge suppression units together
with this.
Do not start or stop the servo
Note
motor with this Magnetic Contactor.
Reactor (L)
Reduces harmonic current of the main
power.
Note
Note that no regenerative resistor is
equipped in Frame A and B type.
Note
This overall wiring diagram is a typical one. The pages after P.2-29 that follow show wiring
for specific application. The wiring indicated with the broken line shall be provided only when
required.
Related page
• P.7-69... "Options"
2-2

1.Composition of Peripheral Equipments

A to B-frame (100 V/200 V Type)
Mains
Residual
current device
Wiring to the Connector, XB
• Connection to external components
Regenerative resistor (optional)
• When you use an external regenerative resistor,
Remarks
install an external protective apparatus, such
as thermal fuse without fail.
• Mount the regenerative resistor on
incombustible material such as metal.
Wiring to the Connector, XA
• Connection to input power
L1 (Pin-5)
L2 (Pin-4)
L3 (Pin-3)
L1C (Pin-2)
L2C (Pin-1)
P.2-29
P (Pin-6)
B (Pin-4)
P.2-29
Rev.2.00