Composition Of Peripheral Equipments - Panasonic MADDT1207 Technical Reference

Composition of Peripheral Equipments

Installation Environment
Use the servo driver in the environment of Pollution Degree 1 or 2 prescribed in IEC-
60664-1 (e.g. Install the driver in control panel with IP54 protection structure.)
Power
supply
Circuit
breaker
Power Supply
100V type : Single phase,
(A, B and C-frame)
200V type : Single phase,
(B, C-frame)
200V type : Single/3-phase,
(C, D-frame)
200V type : 3-phase,
(E, F-frame)
(1) This product is designed to be used at over-voltage category (Installation category) II
of EN 50178:1997. If you want to use this product un over-voltage category (Installa-
tion category) III, install a surge absorber which complies with EN61634-11:2002 or
other relevant standards at the power input portion.
(2) Use an insulated power supply of DC12 to 24V which has CE marking or complies
with EN60950
Circuit Breaker
Install a circuit breaker which complies with IEC Standards and UL recognizes (Listed
and marked) between power supply and noise filter.
Control box
Ground-fault
Noise filter
breaker
(RCD)
Surge
absorber
Protective earth (PE)
+10%
100V
–15%
+10%
200V
–15%
+10%
200V
–15%
+10%
200V
–15%
Controller
Insulated
power supply
for interface
Noise filter for
signal lines
CN X1
L1
L2
L3
L1C
L2C
+10%
to 115V
–15%
+10%
to 240V
–15%
+10%
to 240V
–15%
+10%
to 230V
–15%
– B41 –
CN X5
Driver
Noise filter
for signal
lines
CN X2
Motor
U
V
W
CN X6
50/60Hz
50/60Hz
50/60Hz
50/60Hz
M
RE