Configuration Of Peripheral Equipments - Panasonic MINAS-A4N Reference Specifications

12-2 Configuration of peripheral equipments

12-2-1 Setup environment
Use the servo drive in environment of Pollution Degree 2 or 1 prescribed in IEC 60664-1. (E.g. Install inside of
the control box of IP54)
12-2-2 Power supply
100V type: Single phase 100V to 115V
200V type: (A to D-frame) Single/3-phase 200V to 240V
200V type: (E and F-frame) 3-phase 200V to 230V
(1) Use under environment of over-voltage category-II prescribed in IEC 60664-1.
(2) Use an interface power supply of DC12 to 24V, insulated type, which conforms to CE marking or
EN Standard (EN60950).
12-2-3 Circuit breaker
Connect a circuit breaker which conforms to IEC Standard and is UL recognized (UL Listed and
Marked) between the power supply and the noise filter without fail.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
R2
Power
supply
Circuit Noise filter
breaker
Surge
absorber
Control box
Controller
Insulated power
supply for interface
ＣＮ－X5
Noise filter for
Servo
Noise filter for
signal line
driver
signal line
L1
L2
Ｕ
L3
Ｖ
Ｗ
L1C(r)
L2C(ｔ)
ＣＮ－X4
Protective earth (PE)
+10%
50/60Hz
-15%
+10%
50/60Hz
-15%
+10%
50/60Hz
-15%
Motor Company, Matsushita Electric Industrial Co., Ltd.
No.SX-DSV01676 - 42 -
Servo
motor
Ｍ
RE
U L