Preparations; Section 3 Preparations; Loading Paper; Note When Adding Paper - Kyocera KM-5530 Operation Manual

Section 3

1. Loading paper

Paper can be loading into 5 locations in this copier: the 4
drawers[cassettes] and the multi-bypass tray.

(1) Note when adding paper

After taking new paper out of its packaging, be sure to fan through
them a few times to separate the sheets before loading the paper into
a drawer[cassette] or setting the paper on the multi-bypass tray.
IMPORTANT!
Using special paper
In this copier, the type of paper loaded in each drawer[cassette] and
on the multi-bypass tray can be specified under "Paper type
(drawer[cassette] No.1 - No. 5)" on page 7-24 and "(1) Paper size and
type" on page 7-62, respectively.
Among the special paper that can be use with this copier, there is a
wide range in paper quality and construction especially in those types
of paper noted below. For that reason, there is a greater possibility of
problems occurring during copying with these type of paper.
Whenever you do use such special paper as noted here, it is
recommended that you first make a test copy and verify the results.
<Special paper for which extra caution is recommended>
• Preprinted
• Label sheets* 1
• Prepunched
*1: When using label sheets, be absolutely certain that there is no
possibility that the backing glue will come into contact with any
part of the copier, and that none of the labels will come off the
sheet during copying. If glue does happen to come into contact
with the drum or rollers, or one of the labels comes off inside the
copier, it can be the cause of major damage.

PREPARATIONS

(2) Loading paper into drawers[cassettes] No.1 and
No.2
Up to 500 sheets of standard copy paper (75 g/m
paper can be loaded into each drawer[cassette].
Inch specifications
Each drawer[cassette] can hold paper of any size between
5 " x 8 " and 11" x 17".
1/2 1/2
Metric specifications
Each drawer[cassette] can hold paper of any size between A5R and
A3.
IMPORTANT!
• In metric specification copiers, the size of paper loaded in each
drawer[cassette] must be specified under "Paper size
(drawer[cassette] No.1 & No.2)" on page 7-23.
• The type of paper loaded in each drawer[cassette] must be specified
under "Paper type (drawer[cassette] No.1 - No.5)" on page 7-24.
1 Pull the drawer[cassette] out toward you as far as it will go.
2 Move the paper length guide plates to fit the length of the
paper that is to be loaded in that drawer[cassette].
The paper sizes are marked on the bottom of the
drawer[cassette].
2 – 90 g/m 2 ) or color
3-1