Kyocera KM-5530 Operation Manual page 153

Default setting
Paper type Sets and then displays the type of paper that is loaded in
(drawer[cassette] No.1 - drawers[cassettes] No.1 through No.5.
No. 5) * The drawer[cassette] No.5 setting will only be
displayed when the optional Side Feeder, which is only
available for 55 cpm copiers, is installed on your
copier.
Custom paper type for Sets whether or not each custom paper type (custom 1 -
2-sided copying custom 8) will be available for use in
2-sided copying.
Paper type (for used If a white band (unprinted area) appears on copies
paper) parallel to their direction of ejection when using paper
which has already been copied onto or used previously,
it is possible to minimize the negative effect of this white
area. This setting is applicable to each "custom" paper
type setting ("custom 1" through "custom 8").
* The "Paper type (for used paper)" and "Paper type (for
high-resistance paper)" settings cannot be used in
combination with each other. The setting that was
made most recently will be in effect for the
corresponding "custom" paper type.
Paper type (for high- If a white band (unprinted area) appears on copies
resistance paper) parallel to their direction of ejection when using high-
resistance paper (paper with a high-resistance surface
such as that used for both color and monochrome
copying), it is possible to minimize the negative effect of
this white area. This setting is applicable to each
"custom" paper type setting ("custom 1" through "custom
8").
* The "Paper type (for high-resistance paper)" and "Paper
type (for used paper)" cannot be used in combination
with each other. The setting that was made most
recently will be in effect for the corresponding "custom"
paper type.
Auto shut-off time Sets the amount of time that will elapse after copying, or
if no operation is performed, before the auto shut-off
function engages and turns the copier OFF.
* It is recommended that you try to set a longer time
interval before auto shut-off engages if you use the
copier frequently, and to a shorter time if there are long
intervals between use.
Auto preheat time Sets the amount of time between the point that copying
ends and the energy-saving preheat mode engages.
Section 7 COPIER MANAGEMENT FUNCTIONS
Description Available Factory
settings setting
Plain Plain
Preprinted
Recycled
Letterhead
Color [Colour]
Prepunched
Rough
Bond
Custom 1 –
Custom 8
On / Off On
On / Off Off
On / Off Off
15 – 240 (minutes) 90 (minutes)
1 – 45, 60, 90, 120, 15 (minutes)
180 and 240
(minutes)
Reference
page
7-24
7-25
7-26
7-27
7-27
7-28
7-19