Kyocera KM-5530 Operation Manual page 15

¤
›
fi
fl
‡
⁄
Œ
¤ Original size indicator lines
(Be sure to align the original with these lines whenever setting an
original on the platen.)
‹ Platen
(Set originals here for copying. Lay originals face-down and align
the edges with the size indicator lines located on the left and rear
sides of the platen.)
› Total counter
(This counter displays the total number of copies made on the
copier up to this point.)
fi Main switch
(Turn this switch ON ( | ) before copying.)
fl Copy eject tray
(Finished copies are ejected and stored on this tray. This tray may
be optional equipment in certain countries or regions of purchase.)
‡ Fixing unit handle A
(Operate this handle out if a paper misfeed occurs inside the
copier.)
— Transfer unit handle C
(Operate this handle out if a paper misfeed occurs inside the
copier.)
Section 2 NAMES OF PARTS
‹ ‚
´
„
· Transfer unit release lever B
(Operate this lever when you need to pull out the transfer unit.)
‚ Transfer unit
(Pull this unit out if a paper misfeed occurs inside the copier.)
ΠDuplex Unit
(Pull this unit out if a paper misfeed occurs inside the copier.)
„ Paper length guide release levers
(Pinch these levers and adjust the guide plate to fit the length of
the paper that is to be loaded in that drawer[cassette].)
´ Paper width guide release levers
(Pinch these levers and adjust the guide plates to fit the width of
the paper that is to be loaded in that drawer[cassette].)
·
—
2-3