Kyocera KM-5530 Operation Manual page 63

6 Touch the "Loading Form" key.
A list of registered forms will be displayed.
Inch specifications
Select Form
Scan form
once
Loading
Form
Metric specifications
y
Set form.
Form selection
Press Start key.
Form selection
Scan form
once
LOADING
FORM
7 Select from that list the image that you want to use and then
touch the "Close" key. The touch panel will return to the
screen in step 4.
Inch specifications
Select Form
Form
Form 005
Form 004
Scan form
once
Form 003
Loading
Form 002
Form
Form 001
The arrow means direction of registered form.
Set original and form directions.
Metric specifications
Form selection
Form
Form006
Form005
Scan form
once
Form004
Loading
Form Form003
Form002
The arrow means direction of registered form.
Set original and form directions.
8 Set the originals that you want to copy and go directly to step
10.
Back Close
Overlay first scanned image onto
the scanned image or on registered from.
Paper size Set
Back Close
Back Close
Overlay 1st image on the scanned
image or on registered form.
Close
Back
1200dpi
Up
11x8 1 / "
2
11x8 1 / "
2
8 1 / x11"
2
11x8 1 / "
2
Down
11x8 1 / "
2
Back Close
Up
Down
Section 5 OTHER CONVENIENT FUNCTIONS
9 If you are using the Document Processor, make sure that the
original that you want to use as the form is on top of the
originals that you want to copy.
If you are using the platen, set the original that you want to
use as the form.
10 Press the [Start] key.
Scanning of the originals will start.
If you set the originals in the Document Processor, copying
will start automatically.
If you set an original on the platen, a message will appear
telling you to set the next original. In this case, go to the next
step.
11 Replace the first original with the next one and press the
[Start] key. Scanning of that next original will start.
12 Once you have finished scanning all of the originals, touch
the "Scanning finished" key. Copying will start.
5-21