Adjusting The Simatic Ktp700 Hmi Display Brightness - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

Software user interface
9.1 SIMATIC Keypad
Order Code Meaning
17 COAS Coasting to stop
18 TUNE Auto Tuning
19 FALT Drive fault active
9.1.13

Adjusting the SIMATIC KTP700 HMI Display Brightness

To adjust the KTP700 display brighness, perform the following steps as indicated below:
1. Ensure that NXG control power is ON. The drive MODE must be NOMV, INH, or OFF.
2. Start at the NXG Main Screen with the touch keypad displayed.
Figure 9-20
362
Description
The drive is not controlling the motor and it is coasting to a stop due only
to friction.
The drive is in a "Auto Tuning" mode used to determine motor character‐
istics.
This mode is selected if any drive fault exists, but is not usually displayed
as the fault message is displayed instead. This is shown if the "Fault display
override" (8200) feature is enabled.
NXG Main Menu Screen - touch keypad displayed
NXGPro+ Control Manual
Operating Manual, A5E50491925A