Options For Auto Menu (4) - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

6.11

Options for Auto Menu (4)

Note
Changing Drive Parameters
Only Siemens trained personnel are authorized to change drive parameters.
Familiarize yourself with the safety notes in Section Safety Notes for Parameter Changes and
preferentially contact Siemens customer service before changing the default configuration.
The Auto Menu (4) consists of the following menu options:
• Speed Profile Menu (4000)
• Analog Input Menu (4090)
• Analog Outputs Menu (4660)
• Speed Setpoint Menu (4240)
• Incremental Speed Setup Menu (4970)
• PID Select Menu (4350)
• Comparator Setup Menu (4800)
These menus are explained in the tables that follow.
Table 6-61 Speed Profile Menu (4000) Parameters
Parameter ID
Entry point 4010
Exit point 4020
Entry speed 4030
Exit speed 4040
Auto off 4050
Delay off 4060
Auto on 4070
Delay on 4080
NXGPro+ Control Manual
Operating Manual, A5E50491925A
Unit Default Min
% 0.0 0.0
% 150.0 0.0
% 0.0 0.0
% 150.0 0.0
% 0.0 0.0
sec 0.5 0.5
% 0.0 0.0
sec 0.5 0.5
Max Description
200.0 Set the percent of speed command at which the drive be‐
gins, following the speed command.
275.0 Set the percent of speed command at which the drive
stops, following the speed command.
200.0 Set the speed command to which the drive accelerates
when given a start command, when the speed profile func‐
tion is enabled.
275.0 Set the speed command that the drive reaches at the exit
point.
100.0 Set the level of command at which the drive turns off.
100.0 Set a time delay between the time the command reaches
the auto off point and the time the drive shuts off.
100.0 Set the level of command at which the drive turns on.
100.0 Set a time delay between the time the command reaches
the auto on point and the time the drive starts.
Parameter Assignment/Addressing
6.11 Options for Auto Menu (4)
137