Speed Setup Menu (2060) Parameters; Table - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

Table 6-9

PMM Control Menu
Reactive Cur‐ 2981
rent mode
Output Ids 2982
PMM for Con‐ 2983
veyor
Current Offset 2984
Angle
Current Scan 2985
Angle
Current Scan 2986
Time
Current Stabili‐ 2987
ty Time
Table 6-10

Speed Setup Menu (2060) Parameters*

Parameter ID
Ratio control 2070
Speed fwd max 2080
limit 1
Speed fwd min 2090
limit 1
Speed fwd max 2100
limit 2
Speed fwd min 2110
limit 2
Speed fwd max 2120
limit 3
NXGPro+ Control Manual
Operating Manual, A5E50491925A
Disable
% 0.0 -100.00 100.00
deg Disable
deg 0.0
deg 45.0
deg 10.0
deg 3.0
Unit Default Min
% 100.0 -250.0
% 100.0 0.0
% 0.0 0.0
% 100.0 0.0
% 0.0 0.0
% 100.0 0.0
6.5 Options for Drive Menu (2) - first part
Select output reactive current source method for
PMM control:
• Disabled: I
• Manual: I
• Auto: maintains unity power factor (PF) as
seen from the rotor.
• Manual network: I
• Auto phase advance: enable a voltage regula‐
tor to clamp terminal voltage to rated of the
motor. This method maintains unity PF, as
seen from the rotor, below rated speed to pro‐
duce maximum torque per amp of the motor.
Note: For synchronous transfer of a PMM, the Au‐
to and Auto Phase Advance must be disabled.
Ids, ref (reactive current) as percentage of rated
current. Internal code clamps magnitudes from
getting lower than 1.0 %.
Selects use of PMM with coordinated startup for
conveyors
0.0 180.00 Machine offset angle in electrical degrees
0.0 100.00 Maximum scan angle in electrical degrees
0.0 100.00 Duration of scan in seconds
0.0 100.00 Stabilization of time for current before and after
scan
Max Description
250.0 Adjust the scaling of the speed reference value.
275.0 The forward maximum speed reference limit 1.
200.0 The forward minimum speed reference limit 1.
200.0 The forward maximum speed reference limit 2.
200.0 The forward minimum speed reference limit 2.
200.0 The forward maximum speed reference limit 3.
Parameter Assignment/Addressing
set to zero, no flux regulator.
ds, ref
set manually.
ds, ref
set through network.
ds, ref
103