Siemens SINAMICS PERFECT HARMONY GH180 Function Manual page 108

Parameter Assignment/Addressing
6.5 Options for Drive Menu (2) - first part
Parameter ID
Current Level 2450
Setpoint
Current ramp 2460
Max current 2470
Frequency scan 2480
rate
* If spinning load mode is disabled from this parameter, it will enable automatically on an as-
needed basis; this occurs only when fast bypass is enabled and only for the duration of the
bypass. This action is internal and does not require user intervention. This action does not
affect the spinning load mode paramete.
Table 6-15 Conditional Timer Setup Menu (2490) Parameters
Parameter ID
Cond stop timer 2500
Cond run timer 2510
Table 6-16 Cell Menu (2520) Parameters
Parameter ID
Installed cells/ 2530
phase
Permitted min cell 2541
count
106
Unit Default
% 15.0
sec 0.01
% 50.0
sec 3.00
Unit Default Min
sec 0.8 0.0
sec 0.8 0.0
Unit De‐ Min
fault
4 1
12 3
Min Max
1.0 50.0
0.00 5.00
1.0 50.0
0.00 5.00
Max Description
999.9 Dwell time after stop is invoked. User function de‐
fined.
Not implemented
999.9 Dwell time after start is invoked. User function de‐
fined.
Not implemented
Max Description
8 Number of installed cells per phase in the drive.
24 Set the permitted minimum cell count which establishes
the maximum number of cells that may be bypassed. At
least one cell must be operable in each phase.
A further restriction is enforced in the code to only allow
a maximum of nine cells in bypass. A bypass fault will
occur if the bypass operation attempts to exceed the
number.
Description
Set the drive current level (I
age of motor rated current, used during
scanning.
Time to ramp drive current (I
Level Setpoint.
Set the current trip level to abort spinning
load, as a percentage of motor rated current,
for scanning. Use the default value of 50 %.
Set the time taken to scan from rated speed
to zero. The default value of 3.00 sec is usu‐
ally satisfactory.
NXGPro+ Control Manual
Operating Manual, A5E50491925A
), as a percent‐
d
) to Current
d